Installation HD

Installation Overview

This is only an overview. Please download the full instruction manual (above right)
or watch the video (above left) for full installation instructions.

02

WARNING
Do not attempt to install SkyBell in wet conditions. Do not proceed if you, SkyBell or the area around your door is
wet. SkyBell can only be attached to a low voltage transformer (12-36 VAC) and not directly to primary power
(110/120 VAC and 220/230/240 VAC). If you do not use a doorbell chime, you MUST use a 10 ohm/10 watt resistor between SkyBell and one wire from the power source. Resistor not included in packaging.

03

Remove current doorbell.

install_3

04

Screw baseplate into wall

install_4

05

Attach each SkyBell wire to a home doorbell wire with the blue connectors. If no doorbell chime, you must use a resistor. See power diagrams for more info.

install_5

06

Place device on mounting plate, make sure device
is flush to wall.

install_6

07

Insert locking tool in small hole at bottom of device. Turn 3 whole rotations to the left to secure device in place. See video!

install_7

Videos

Additional Wall Mounts - Coming Soon

Door Frame Adapter

door_frame_adapter

Wedge Mount

wedge_mount