Read the Pre-Installation Checklist
Do not attempt to install SkyBell in wet conditions. Do not proceed if you, SkyBell or the area around your door is
wet. SkyBell can only be attached to a low voltage transformer (12-36 VAC) and not directly to primary power
(110/120 VAC and 220/230/240 VAC). If you do not use a doorbell chime, you MUST use a 10 ohm/10 watt resistor between SkyBell and one wire from the power source. Resistor not included in packaging.
Remove current doorbell.
Screw baseplate into wall
Attach each SkyBell wire to a home doorbell wire with the blue connectors. If no doorbell chime, you must use a resistor. See power diagrams for more info.
Place device on mounting plate, make sure device
is flush to wall.
Insert locking tool in small hole at bottom of device. Turn 3 whole rotations to the left to secure device in place. See video!
Additional Wall Mounts - Coming Soon
Door Frame Adapter